ETH Copy Trade
Last updated
Last updated
You can enter the Copy Target Page by clicking Copy Trade on Home Panel.
Enter your copy target address on the Copy Target Page.
You can set up to 2 copy targets. This page shows your current copy targets and the number of copy transactions.
You can see the balance of the target address and the number of its followers on the Copy Order Submission Page.
Select the wallet, and make sure its balance is not less than 0.01 ETH.
You can choose Copy Buy Only and then sell tokens manually. Or choose Copy Buy&Sell, which means when the target address makes a sell transaction, your copy order will trigger one at the same ratio as the target's buy/sell ratio.
You can turn on Auto Slippage, the system will help to set an appropriate value based on the network conditions when triggering a transaction. You can also choose to turn off them and set the values yourself.
You can set up a Gas Multipiler so that your transaction gas is times the transaction gas of the traget. In order to perform copy transactions with a high success rate, we recommend a Gas Multipiler of no less than x1. You can set the Maximum Gas in case of occasional large increases in gas.
You can choose Fixed Buy Amount with a minimum of 0.01 SOL. Or choose Same Buy Ratio, that is, spend the same proportion of the SOL balance as the target address.
Click Submit Copy Order, now your copy order is set up successfully. It should be noted that if your SOL balance is insufficient to pay for the transaction when it is triggered, the system will automatically cancel your copy order. Please pay attention to the system notifications and keep your wallet balance sufficient.