Solana Copy Trade
Last updated
Last updated
You can enter the Copy Target Page by clicking Copy Trade on Home Panel.
Enter your copy target address on the Copy Target Page.
You can set up to 2 copy targets. This page shows your current copy targets and the number of copy transactions.
You can see the balance of the target address and the number of its followers on the Copy Order Submission Page.
Select the wallet, and make sure its balance is not less than 0.1 SOL.
You can choose Copy Buy Only and then sell tokens manually. Or choose Copy Buy&Sell, which means when the target address makes a sell transaction, your copy order will trigger one at the same ratio.
You can turn on Auto Gas and Auto Slippage, the system will help to set an appropriate value based on the network conditions when triggering a transaction. You can also choose to turn off them and set the values by yourself.
Thunder Mode or Anti-MEV Mode, as needed.
You can choose Fixed Buy Amount with a minimum of 0.01 SOL. Or choose Same Buy Ratio, that is, spend the same proportion of the SOL balance as the target address.
Click Submit Copy Order, now your copy order is set up successfully. It should be noted that if your SOL balance is insufficient to pay for the transaction when it is triggered, the system will automatically cancel your copy order. Please pay attention to the system notifications and keep your wallet balance sufficient.
After a copy transaction is executed, a push message will be sent to you, as shown in the figure below.
You can also click Copy History on Copy Target Page.
Switch the copy target to view the number of copy transactions, buy/sell/hold amounts, PnL of each token.
Click View Copy Transfer Flow to see all your copy transactions for the target address, which are sorted in reverse order by transaction time.